Back to Brands
2121 WALL & FLOOR

2121 WALL & FLOOR

C2T
  • Easy to mix, Just add water & Apply.
  • Agreeable for fixing ceramic tile on Wall [Size up to 24X24"], Floor [Size up to 39X39"] inside only [as well as tile on tile].
  • Maximum thickness up to 10MM.
  • Coverage: Dependent on the substrac surface profile, Roughness and application technique.
    As per guide for a single Adhesive layer.
Notched Trowel Size Coverage Size of Tiles
6MM 2-3 KG/M² Small
8MM 3-4 KG/M² Medium
10MM 5-7 KG/M² Large
TECHNICAL DATA
Pot Life [23°C] : 120 Mins.
Dry Cond. : 1650 N
Open Time : 20 Mins.
Traffic Time : After 24 Hrs.
Colour : Grey
Enquire Now
Instant Bag Estimator

Calculate Required Bags of Retical 2121 Wall & Floor

Enter your project area & select bed thickness (6mm / 8mm / 10mm) to estimate how many 20 KG bags you need.

ft
ft
6mm / 8mm / 10mm
Need custom tile sizes or comparisons? Open Full Calculator
Estimated Requirement
5 Bags

Standard: 20 KG Bag (Total: 100 KG)

Coverage per bag: 24.85 sq. ft.
Total Area: 100.00 sq. ft.
Order These Bags on WhatsApp

*Note: Coverage is based on standard technical mortar density. Actual consumption may vary marginally based on substrate levelness and notched trowel angle.

DIRECTIONS FOR USE

1

PREPARE

Ensure the surface is completely cured, structurally sound, clean, level, and free of dust, dirt, or oil. Lightly dampen the surface with water before application.

2

MIX

Gradually add the 20 KG powder to clean water (approx. 5 to 6 liters). Mix manually or with a slow-speed stirrer to achieve a smooth, lump-free paste. Let the mixture rest for 5-10 minutes, then remix before use. (Pot life is approx. 60 minutes).

3
Trowel

APPLY

Spread the adhesive uniformly on the prepared surface using a suitable notched trowel (up to 10mm thickness). For large format tiles or stones, apply a thin layer of adhesive on the back of the tile as well (back-buttering) to ensure 100% coverage.

4

FIX

Press the tile firmly into the wet adhesive with a slight twisting motion within the open time (30 minutes). Tap gently with a rubber mallet to eliminate air pockets.

5

CURE

Clean any excess adhesive from the tile face and joints with a damp sponge immediately before it dries. Allow at least 24 hours to cure before grouting or permitting foot traffic.